Community guidelines — the short version

Appreciate the clear steps. The dry-run tip in particular saved me from a mistake I would not have caught otherwise.

I respectfully disagree on one detail. In my setup the opposite held true, though I suspect it comes down to community size.

Thanks for writing this up. Bookmarking it — the kind of thing I will want to reference again in a month.

Strong agree. Good defaults beat a wall of toggles every single time.

This deserves more votes. It is a small change with an outsized impact on day-to-day use.

This is the answer I wish I had found six months ago. Would have saved me a weekend of trial and error.

Adding a small note: the same idea applies on mobile, just with a bit more attention to tap targets.

I respectfully disagree on one detail. In my setup the opposite held true, though I suspect it comes down to community size.

This matches my experience exactly. The hard part is staying consistent once the initial novelty wears off.

Strong agree. Good defaults beat a wall of toggles every single time.

One caveat for larger communities: keep an eye on the indexes. At a few thousand rows the difference is night and day.

We ran into the same situation last quarter. What worked for us was starting small and only adding complexity when a real need showed up.

For what it is worth, the same approach works with the PMPro adapter — the membership side is identical from here.

Could you say more about how you measured the result? I want to try this but I am not sure what success would look like.

Following this thread closely. We are about to face the exact same decision and the replies here are gold.

I respectfully disagree on one detail. In my setup the opposite held true, though I suspect it comes down to community size.

This is the answer I wish I had found six months ago. Would have saved me a weekend of trial and error.

For what it is worth, the same approach works with the PMPro adapter — the membership side is identical from here.

We ran into the same situation last quarter. What worked for us was starting small and only adding complexity when a real need showed up.

For what it is worth, the same approach works with the PMPro adapter — the membership side is identical from here.

One caveat for larger communities: keep an eye on the indexes. At a few thousand rows the difference is night and day.

Great point. I had not considered the angle you raised in the second paragraph — it reframes the whole thing for me.

Tried this on a staging copy first and it behaved exactly as described. Confident enough to roll it to production now.

Following this thread closely. We are about to face the exact same decision and the replies here are gold.

Strong agree. Good defaults beat a wall of toggles every single time.

One caveat for larger communities: keep an eye on the indexes. At a few thousand rows the difference is night and day.

Tried this on a staging copy first and it behaved exactly as described. Confident enough to roll it to production now.

Could you say more about how you measured the result? I want to try this but I am not sure what success would look like.

This deserves more votes. It is a small change with an outsized impact on day-to-day use.

This matches my experience exactly. The hard part is staying consistent once the initial novelty wears off.